Pneumatic Cylinder (SC 63X150)

SC Pneumatic Cylinder
Installing and useThe load would be changed during working, so, the cylinder with enough output force issuggested, in the case of high temperature, operator is suggested to choose correspondingwithstand high-temp cylinder.
Before piping of cylinder, the sundries inside pipe must be cleaned, in order to preventsundries from entering into cylinder.
The medium used by cylinder can not be put into use until it has pass filtering by certainfiltering element above 40 μm.
Under condition of low temperature, the anti-freezing measure must be adopted, so as toavoid water freezing of system engineering.
The idling test run should be done before operating of cylinder, the buffer must be adjustedto be minimum before run, then increased gradually, so as to avoid producing super-largeshock damaging cylinder.
The cylinder should avoid side-load as for as possible during working, in order to maintainnormal work endurance of cylinder.
Provided cylinder has been out of work for long time dismantled, operator should take noticeof surface rustproof, the dustproof cap is suggested to be added at air admission/exhaustorifice.